|
Electrical
Testing & Tagging Training Courses
With
the introduction of inspection and testing of electrical equipment in the
workplace more &
more businesses are having their staff trained to carry out this task. This is not only cost effective, especially for organisations
that have a large number of appliances, but also reduces the risk of
non-compliance which can involve substantial fines.
There
are a number of Registered Training Organisations that deliver a Nationally Recognised Training course
from the "Electrotechnology
Training Package" being the unit UEENEEP008B:
'Conduct in-service
safety testing of electrical cord assemblies and cord connected equipment'.
Registered
Training Organisations that deliver this unit of competency
NSW &
ACT -
NSW Electrical Test &
Tagging Pty Ltd
Web:
www.testntagnsw.com.au
Email:
sales@testntagnsw.com.au
PH:
02 4628 8986
FAX:
02 8004 8116
VIC
- Test & Tag Training
Web:
www.testandtagtraining.com.au
Email:
enquiries@testandtagtraining.com.au
PH:
1300 848 302
FAX:
1300 848 312
Download
the Unit of Competency UEENEEP008B
On
successful completion trainees receive a "Statement of Attainment"
which is recognised through out Australia. A Statement of Attainment is
issued by a Registered Training Organisation when an individual completes
one or more units of competency from a nationally recognised qualification(s)
and or course(s).
Plug Top
Replacement
In
some States you maybe required to have been trained and assess and found to
be competent to fit a plug
and or a socket on an electrical appliance or leads if you are not electrically
qualified.
For
example:
NSW
WorkCover's guide to Testing and Tagging of Electrical equipment states
"Plugs and extension sockets may be replaced by a non-electrically
qualified person provided the person has been trained, assessed and found to
be competent to fit plugs and sockets according to the manufacture's
instructions."
NSW
Electrical Test & Tagging have developed a course to satisfy the
requirements of WorkCover NSW for the replacement of single phase plug tops
and sockets on extension leads and appliances by non electrically qualified
persons. The course duration is approximately 2.5 to 3 hours and covers a
multitude of plug and sockets, ingress protection and tips. It is a
requirement that a person attending this course must have successfully
completed a recognised electrical test and tagging course.
For
further information on this course you can visit -
in
NSW www.testntagnsw.com.au
in
VIC www.testandtagtraining.com.au
|
Electricaltagging.info 
